UM:Application Preferences Colour
The Colour preferences screen specifies global configuration settings controlling colour related controls and display.
Trackball OrientationThis specifies the orientation used for the colour-correction trackballs, both on the control panel and the GUI interface.This configures the colour arrangement on the trackball.
Values : |
Vector. Offset, Offset 30, Offset 330 |
Default : |
Vector |
As you change this setting the trackball image next to the drop-down will update, indicating the current colour orientation :
Printer Points Per F-Stop
Range : |
User set |
Default : |
8 |
This setting specifies the number of printer points used to represent an f-stop for the printer lights tool.
Positive
With the Positive setting enabled, the number you enter will add colour. Uncheck Positive to remove colour.
Printer Neutral
Range : |
User set |
Default : |
25 |
This value represents no change in the printer lights settings.
Default Layer Show Mode
Values : |
Red,Green,Blue,Cyan,Magenta,Yellow,White,Black,Grey,Saturated |
Default : |
Grey |
Values : |
Inside Area, Outside Area |
Default : |
Outside Area |
These settings correspond to :
• | Show As |
• | Show Area (In/Out) |
in the Router settings for each CC/Effect layer.
Default Keyer Input
Values : |
Previous, Base, Start |
Default : |
Start |
This configures which layer a Keyer effect will use as input and corresponds to the layer Router setting Key Input.
• | Start - use input of Base Layer as input |
• | Base - use output of Base Layer as input |
• | Previous - use previous layer as input |
This is the threshold below which compare mode differences will not be registered. A higher value means we are less sensitive to difference.
Range : |
User set |
Default : |
5 units |
This parameter controls the default scaling mode used on a new project. See Project Colour Scaling.