GoldenEyeFixes 2016.1 R1
From DigitalVision
GoldenEye Fixes
2016.1.019
- GE-212 Overwriting existing audio file will make the scanner stop recording
- GE-280 Wrong labelling on sprocket wheel 65
- GE-292 Moving between different settings tabs resizes diagrams panes with 'show zoom' enabled
- GE-416 Image freezes when using the scroll bars in Zoom mode
- GE-478 Storage Format: tiff big endian auto and 16bit bit grayscale export corrupt image
- GE-481 Changing from 4K A35mm to 2K A35mm in the same session will crash the system during the shading calibration
- GE-485 Golden Eye software always adds quarter or half a frame extra to scanned sequence
- GE-487 Shading calibration calculates negative reference exposures
- GE-535 Clean Scanner pop up window needs updating
- GE-555 Sync problem with clear film base where the threshold of the perforation isn't correct
- GE-567 LED Voltage Supply Turn Off Command
- GE-571 Error about film definitions file after turning on the scanner
- GE-573 LED Calibration Error appearing on startup
- GE-576 Change default output from Lin to Log/Use Dmin and Dmax when opening a new session
- GE-600 Remove pop up windows during a 8-Piece Shading Calibration
- GE-601 Hide in the developers mode GUI Output Lin Status, Log Status and Log Raw
- GE-602 Fine Line problem when scanning faster then 8fps
- GE-622 When installing the Gecko - the terminal reports OK - but the Windows install message remains open
- GE-623 When installing the Gecko the terminal reports that drivers failed to load
- GE-626 With a BMD vid card installed GE4 can only use the default file format
- GE-636 Crash caused by entering zoom mode with RGB zooming enabled
- GE-650 Rename "Overview Speed" to be "Play Speed"
- GE-664 Software Crashing on recording with timecode
- GE-670 Crash on opening session or creating new session while playing or recording
- GE-672 For all up or downloads - detect and list errors and show progress
Gecko
- GE-443 When using Go To and rewind the framing is off by one frame
- GE-492 Wheeldata file needs to be updated for 9.5mm film in Gecko
- GE-555 Sync problem with clear film base where the threshold of the perforation isn't correct
- GE-602 Fine Line problem when scanning faster than 8fps
- GE-614 When using Go To in rewind the accuracy is less when spooling over 2500 frames
- GE-622 When installing the Gecko - the terminal reports OK - but the Windows install message remains open
- GE-645 Step forward or backward doesn't update the image view
- GE-665 Goto doesn't consistently update the image view with the landing frame
- GE-674 Using Go to from 0 to 499 with auto sync the frame a perf out
- GE-675 Using Set forward or backwards with auto sync doesn't update the monitor and the counter jumps a couple of frames